PureThermal Breakout Board with FLIR Lepton 3.5

  • PureThermal Breakout Board with FLIR Lepton 3.5


PureThermal Breakout Board with FLIR Lepton 3.5

The PureThermal Breakout Board is an easy to interface evaluation board used to quickly evaluate the FLIR Lepton® thermal camera modules. It’s compatible with many low-cost ARM based evaluation boards, in addition it’s easy to connect to pin outs for Arduino or via short jumper wires to Raspberry Pi.


  • Compatible with Lepton 2.x and 3.x
  • Access to SPI and I2C camera module interfaces
  • Provides 25-MHz reference clock
  • Provides Power Regulation from 3.3-5V input
  • 32-pin Molex camera socket for Lepton® Module
  • PureModules compatible connector
  • VSync and Enable Pins


  • Thermal Imaging
  • Non-contact temperature measurements
  • Motion Sensing
  • Night Vision
  • Gesture Recognition


  • Power Inputs: 3.3-5V
  • Maximum Input Voltage: 5V
  • Lepton Core Support: Lepton 2.x and 3.x
  • Thermal Video Outputs: SPI
  • PureThermal Mini Part Number: GG-PURETHERMAL-BB1.0
  • PureModules Connector: AVX: 009159010061916

Essential Resources


Pin 1 - SCL: Camera Control Interface Clock, I2C
Pin 2 - SDA: Camera Control Interface Data, I2C
Pin 3 - VIN: 3-5 V Supply input
Pin 4 - GND: Common Ground
Pin 5 - CLK: Video Over SPI Slave Clock
Pin 6 - MISO: Video Over SPI Slave Master In Slave Out
Pin 7 - MOSI: Video Over SPI Slave Master Out Slave In
Pin 8 - CS: Video Over SPI Slave Chip Select (active LOW)
Pin 9 - VSYNC: VSync
Pin 10 - EN: Enable, Active High

Important Information

  • All international customers that are ordering any Thermal Imaging Camera will be required to fill out an End Use Statement document before shipment. Once you place your order we will email you with the document within one business day.
  • We can only ship this product to North America, Australia, and the European Union Countries. Any orders placed in a country other than those will be canceled and refunded. We are sorry for the inconvenience.