GetLab

PureThermal Breakout Board

$39.99
  • PureThermal Breakout Board

GetLab

PureThermal Breakout Board

$39.99
The PureThermal Breakout Board is an easy to interface evaluation board used to quickly evaluate the FLIR Lepton® thermal camera modules. It’s compatible with many low-cost ARM based evaluation boards, in addition it’s easy to connect to pin outs for Arduino or via short jumper wires to Raspberry Pi.

Features

  • Compatible with Lepton 2.x and 3.x
  • Access to SPI and I2C camera module interfaces
  • Provides 25-MHz reference clock
  • Provides Power Regulation from 3.3-5V input
  • 32-pin Molex camera socket for Lepton® Module
  • PureModules compatible connector
  • VSync and Enable Pins

Applications

  • Thermal Imaging
  • Non-contact temperature measurements
  • Motion Sensing
  • Night Vision
  • Gesture Recognition

Specifications

  • Power Inputs: 3.3-5V
  • Maximum Input Voltage: 5V
  • Lepton Core Support: Lepton 2.x and 3.x
  • Thermal Video Outputs: SPI
  • PureThermal Mini Part Number: GG-PURETHERMAL-BB1.0
  • PureModules Connector: AVX: 009159010061916

Essential Resources

Pinouts

Pin 1 - SCL: Camera Control Interface Clock, I2C
Pin 2 - SDA: Camera Control Interface Data, I2C
Pin 3 - VIN: 3-5 V Supply input
Pin 4 - GND: Common Ground
Pin 5 - CLK: Video Over SPI Slave Clock
Pin 6 - MISO: Video Over SPI Slave Master In Slave Out
Pin 7 - MOSI: Video Over SPI Slave Master Out Slave In
Pin 8 - CS: Video Over SPI Slave Chip Select (active LOW)
Pin 9 - VSYNC: VSync
Pin 10 - EN: Enable, Active High