Skip to product information
1 of 3

GroupGets

PureThermal 3

Regular price $119.99 USD
Regular price Sale price $119.99 USD
Sale Sold out

PureThermal 3 (PT3) is a hackable thermal webcam for the FLIR Lepton (2.x - 3.x and FS) LWIR camera core. It has the same basic functionality of the PureThermal 2 but with a few changes and additional features. Unlike the PT2, the PT3 does not have pads to install an RF shield and the Tag-Connect TC2030 programming connector is replaced by the Tag-Connect EC-10-IDC.

Design, PCB Fabrication, and Assembly Done in the USA!

New Features:

  • USB-C connector
  • Flash custom firmware with USB DFU
  • Castellated edge with full JTAG breakout for rapid flashing
  • Better buttons for Boot and Reset
  • 3x STM32F412CG GPIO pins
    • PC15, PA0, PH1
  • Breakout for SPI to communicate directly with the Lepton
    • SPI bus is 3V with a 56 Ohm series resistor
  • Partially MikroBUS™ compatible breakout pin configuration

    Features:

    • STM32F412 ARM microprocessor: Execute on-board image processing without the need for an external system or SBC.
    • USB UVC works on Windows, Linux, Mac, and sometimes Android
    • Open source reference firmware is on the GroupGets Github
    • Open source reference image viewer software for Linux and macOS
    • USB-C connector
    • Flash custom firmware with USB DFU
    • Castellated edge with full JTAG breakout for rapid flashing
    • Better buttons for Boot and Reset
    • 3x STM32F412CG GPIO pins
      • PC15, PA0, PH1
    • Breakout for SPI to communicate directly with the Lepton
      • SPI bus is 3V with a 56 Ohm series resistor
    • Partially MikroBUS™ compatible breakout pin configuration

    Resources:

    PureThermal 3 Datasheet

    Software

    Mechanical:

    Weight : <3g without Lepton

     

    Press:

    PureThermal 3 board embeds FLIR Lepton FS thermal camera for $200 - CNX Software

     

    GroupGets Launches the PureThermal 3, a $200 Hackable FLIR Lepton FS Thermal Camera Board